Gave it a quick spin. Plays alright, nice rule approximation I can see so far. I couldn’t get the backless to display for some reason, had the apron ultra DMD section working. Great work. will test and play properly when I have more time
I might have to add back in my undercut lights. I just had standard LED colour changers in there but the adhesive kept making them fall off. If i could wire them in as adressables via the teensy it might be worth re-wiring again
I use similar small 12v solenoids like Borg for all my setup. I have considered putting in contactors since, but i don’t want to have to change over to another 24v power supply to run them. I already have a 12v and a 5v serparate power supply in the cab
the problems you describe can happen if you are using an older version of VP than what the table was developed for. eg. Vp1o instead of 10.4. there are slight tweaks. Update Vpinball and redownload the table.
are you using a real DMD/pin2dmd variant? This is one of the few Gottlieb tables that doesn’t output to a secondary device for display. You will need to display grill on the b2s for it to work as the only option unfortunately.
Thanks Loserman. Working my way through your new VP10 versions. In this one, the ball gets stuck in the left outlane between the rubbers. i wasnt able to adjust this well enough to get it reliable as a fix.
im not a good enough player to use flipper staging anyway. i always feel off on the virtual cab compared to a real anyway. i currently have microleafs for my flippers, so id ned to swap the flipper buttons completely to support this, plus the code change