Mihos

I have a few friends who love playing my cabinet, so they might be into this since they don’t have the room or time I have to go to a full cabinet.  I think that last pin table they made was about $499, so maybe a good balance for them.

I have it working now, not sure exactly what did it but all my FP/PUP tables are working now.  It may be something I did when moving some screens around.

if "" == "PUP" (
REG ADD "HKCUSoftwareFuture PinballGamePlayer" /v "ArcadeMode" /t REG_DWORD /d 0 /f
REG ADD "HKCUSoftwareFuture PinballGamePlayer" /v "SecondMonitorEnable" /t REG_DWORD /d 0 /f
)

START "" "LaunchVPXSTARTER.exe" 5 5 20 "Future Pinball"

rem This will load Future Pinball and your selected table using BAM (Better Arcade…[Read more]

Fun table!

I had to update just about everything, which I needed to do anyway.

I do have a weird issue where sometimes my DMD doesn’t show up and I have to restart the table…. but that happens with all my FP tables using pupdmd.  (using a pindmdv3). It is only a mild annoyance since everything works fine after that.

You read my mind!  I was going to look into that and the backglass thing this weekend.

It looks much better in black:

Thanks for the update!

That’s awesome!  I will test them both out tonight.

I did get as far as mirroring them with dmdext, but they were rotated sideways where I left off.  I was looking into patching in a rotate method to freezy (which I still might do, when I get some free time).

Great table!

Will probably hold off on adding it to my playlist because of the DMD thing, though.

I have a Super Mario Galaxy table that is in the same boat

Love the table!

But I have an issue where if you shoot the mustang store, the ball animation stops and you get a ‘operator right scoop error’ shows on the DMD.  Everything else works fine.  Not sure what it could be…

I recieved my v3 kit and installed it 2 days ago and was experiencing the plunger disconnect… it was absolutely maddening so I looked into a little more

An unshielded i2c connection over that distance in an enclosure as noisy as a VP cabinet is a bad design choice.

To fix it, all I had to do is shield the cable between the plunger and the…[Read more]