nmooer

Thank You!

Thank You so Much! Going to give it a shot!

The pinball machine is now in its place next to my Dodge viper Machine. This is a pic of my father playing that awesome table of Randr’s.  The only mods that I want to do now are a chime unit, and change out those microswitch flipper buttons to leaf switches.  If I can figure out how to add a video I will post some. Do I use YouTube for that? I…[Read more]

The addressable leds. Were my biggest pain in the butt. I started out with one data line running on the system, It was very slow and stuttered. I ended up moving to three separate data lines Left playfield, right playfield and back matrix. I just had too many leds for it to work properly. I would like to give a thanks to Outhere. Without his…[Read more]

Here is a pic from the rear of my machine with the slide out led wiz boards and fuses. I mounted a bell to the left of the cab back. I have to say I wish more games had the bell. when it rings it makes a guy smile.

Here are some pics of the machine all wired up. The amp sub and speakers all done. You can see the blower motor, and shaker motor, and knocker, Got a little clean up of wires around the computer yet. But over all very happy with the layout.  The fuse location in the front for the knocker, shaker and addressable leds have proven to be very helpful…[Read more]

Hi Guys and Gals. Happy New Year!  I have been so busy the last few months with work to post, so here are some updates. The contactors were not loud enough for my liking so I drilled holes in them and put a metal washer in the bottom.  Made them just a little louder to keep up with the sound system.

Thank you! Can’t wait to try it!

Thank you! Going to try it tonight.

Wow! I am putting this on tonight! Thank you so much! Now that you have the dodge charger drawn up, how about a dukes of hazards table.

Thank you so much outhere!! You were right. Too many leds for 1 data line. It works and is beutiful. I have to clean up the wireing. Just hooked it up to see. Will post some videos in my cabinet build when I get back. Thanks again for the patience. I did learn something!  It looks great and I dont have the jumper on.

Do you know off the top of your head what colors I would use for the cat cable for the next two led strips. I believe I have orange now.  Woud I have to change anything else in my xml or dof config. I can try this. I might try cutting my jumper cable first to see if this is an issue. I can always solder another on.  Thanks again so much for your h…[Read more]

outhere. Now that I turned on the log would that show anything interesting to help this. we must be close.  I tried the other teensy strip controller Hex files 1.01 and ended back with the newest. That did not change anything.

Ok, I tried medieval madness and did not have a thing. The teensy was flashing fast. The matrix cleared out from masters of the universe and not a thing just my dof toys.

Ok I turned those to true. The lights stayed on matrix when I logged out of vp

I got some lights. It flashed for launching the first ball on he man. Then the back board flasher turned on and stayed that way. I will go turn that on. I will owe you big thank you!!

Thanks, I missed that. It should be 141. I will try again.

right now out of the vp software it is doing a double blink. trying to look it up. yes it was flashing fast but no lights.

still no led show yet. Must be close. It is trying to send a signal.

ok, Something is happening now. I loaded bad cats and the teensy went  from a solid flash to a rapid flash. so fast almost solid. I don’t know what that means. Should I be cutting my jumper wire on the teensy to see what happens?