hello… thanks for the table. The auto plunger didn’t work on multiball , any solution ?
@vothar if you’re using an analog plunger like the Virtuapin you may have to adjust the plunger position a bit for the auto-plunger to engage properly. In the editor select the plunger and increase it’s Y position value to 1904.004 (this value worked for me). Doing this will move the plunger back a bit and should allow for the auto plunger to work as designed. The exact value of the Y position may have to be tweaked a bit based on your specific plunger calibration, keep in mind if you move it back too far you won’t be able to physically plunge the ball. Do not change the X value. Don’t forget to save after you’re done.
You need to login in order to like this post: click here
