I know everyone can’t keep up with everything I’ve posted but I’m not building a cabinet. My cabinet was built in 2013 I’m just replacing a few parts. A lot of these options did not exist back in 2013/2014. I already found the pinscape website as I mentioned in my post above but like I said I had already bought the virtuapin plunger so I thought maybe someone smart had figured out how to put better firmware in the board. I do plenty of DIY building but I weigh the cost of buying something new versus the cost of my time. I could probably write the firmware for the KL25Z myself but again not sure that’s how I want to spend my hours. If no one has any good advice I’ll get this figured out on my own.
You need to login in order to like this post: click here
