- This topic has 1 reply, 1 voice, and was last updated 3 years, 7 months ago by
.
-
Posts
-
Hey guys, sorry if this has been asked, i’ve looked and gave up trying to find anyone else who mentioned this issue:
Just set up a new cab: Installed popper, with VP Tables w/full DOF working. Added my FX3 tables, and so far so good
Add doflinx and setup the INI file with the wizard.
Open a table, and all is great.
A few days later (and a few days of me “tinkering”) i launch a fx3 table and my left flipper is now assigned to my shaker motor. The right flipper is fine.
I assume its something that i did during my Tinkering, and blow away my INI file and start from scratch.
When done, i load a table, and all is great.
All of the sudden, a few reboots later, no tinkering. My left flipper is back to my shaker motor.
Has anyone come across this? according to my INI file, the flippers are assigned properly. but in FX 3 (VP is fine with reg DOF) that flipper isn’t mapped right?
Thanks
You need to login in order to like this post: click here
Got it sorted, it was only Attack from mars doing acting weird
You need to login in order to like this post: click here
Forums are currently locked.
