- This topic has 2 replies, 2 voices, and was last updated 3 years, 2 months ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
Viewing 3 posts - 1 through 3 (of 3 total)
RELUCTANTLY enabled site for everyone to view for historical reference only. Downloads area not publicly available.
Wasn’t sure what section to put this in…
i
when I reinstalled my plunger with the linear pot, I went to recalibrate it and the range on the pull is very small now
you can see in the pic how it’s all on the right side when before it was all the way across that bar.  It works but it is very jumpy now.  I didn’t change any settings in VPX or pinscape, which is what it’s hooked up to
You need to login in order to like this post: click here
That’s how mine was and after trying to calibrate it 20 times I realized I had the wires wrong.
Hi my name is Barry and I'm a virtual pinball addict.
You need to login in order to like this post: click here
Ahh. Â I will check again tanks
You need to login in order to like this post: click here
Forums are currently locked.
©2024 VPinBall.com