- This topic has 1 reply, 1 voice, and was last updated 3 years, 10 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
Viewing 2 posts - 1 through 2 (of 2 total)
RELUCTANTLY enabled site for everyone to view for historical reference only. Downloads area not publicly available.
Hi! I recently decided to start exploring DOF and have run into an issue with under cabinet lighting. I am using a jamma power supply I had lying around to send 12v to an led amplifier. I have RGB connections (no power) from an ledwiz connected to the “input” side of the led amplifier and the LEDs connected to the “output” side of the amplifier. I tested the LEDs with a multimeter and they are receiving 12v, but I get no light when I try to run the simple led test in led blinky. I have tried different ports on the ledwiz and different led amplifiers. If I hook the 12v directly to the led strip and touch ground to the copper connections, they light up. I am new to DOF and hoping this is just something obvious I am missing. Any help is greatly appreciated!
Thanks,
Cj
You need to login in order to like this post: click here
I figured it out. Rookie mistake, I did not have the ground from my second psu hooked to the led wiz. I also think I had a loose connection at the mini amplifier.
You need to login in order to like this post: click here
Forums are currently locked.
©2024 VPinBall.com