- This topic has 2 replies, 2 voices, and was last updated 5 years, 3 months ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
Viewing 3 posts - 1 through 3 (of 3 total)
RELUCTANTLY enabled site for everyone to view for historical reference only. Downloads area not publicly available.
Hello,
I have installed a small 12V gear motor to my homebuilt Pinscape board.
Everything works as is, but I’d like to reduce the speed because the very high RPM doesn’t feel natural.
Is it possible to set a default PWM value for the gear motor somewhere? Like 30% or similar.
The Pinscape Config tool has a slider for testing PWM outputs, so I have tried and know it is possible.
I don’t need different setting for each table, just a one time permanent adjustment.
Can’t find where to do it…
You need to login in order to like this post: click here
Hi!
you can add “flipper logic” to that particular output! Check the small icon an hover your mouse button over it for explanation ;)
greetz,
Dom
You need to login in order to like this post: click here
Thanks! Got similar info at another forum too.
Tried it now, and it works perfect.
You need to login in order to like this post: click here
Forums are currently locked.
©2024 VPinBall.com