Strange Patterns Addressable LEDs

[randr]

Also test a table that has custom effects like mad scientist, acdc, heman or jaws that way you can rule out your combos as messing it up. shameful plug to try mad scientist!

********************************************************
Messing with the VPinball app and push notifications.
So if you haven't downloaded app yet what are you waiting for!?
for IOS and Android

********************************************************

You need to login in order to like this post: click here

[Josh]

ok I ran a basic Arduino pattern the matrix is bottom up alternating right to left with the first pixel in the bottom right corner of the matrix

You need to login in order to like this post: click here

[randr]

So i assume then your “BottomUpAlternateRightLeft”

OR “BottomUpRightLeft”

********************************************************
Messing with the VPinball app and push notifications.
So if you haven't downloaded app yet what are you waiting for!?
for IOS and Android

********************************************************

You need to login in order to like this post: click here

[Josh]

I believe its bottomupalternate right left…..here is the mad scientist link I assume this ones a bit off too?

 

https://youtu.be/mXlT8HLIrsc

You need to login in order to like this post: click here

[randr]

Remove your combos in dof tool for now i think your overlaying sides on matrix or something…just remove them for test

this is how mad scientist should look skip to like 1:30 in video

********************************************************
Messing with the VPinball app and push notifications.
So if you haven't downloaded app yet what are you waiting for!?
for IOS and Android

********************************************************

You need to login in order to like this post: click here

[randr]

Here is my combo setup. Sorry bad pictures

********************************************************
Messing with the VPinball app and push notifications.
So if you haven't downloaded app yet what are you waiting for!?
for IOS and Android

********************************************************

You need to login in order to like this post: click here

[Josh]

I ran out of time and couldn’t figure out how to set it up without combos.  I also made sure all of my settings in the DOF mirrored your setup maybe your xml will tell me something…thanks again for all the help

You need to login in order to like this post: click here

[randr]

here is my xml attached.

If you just change number of leds to your setup  it should work or just use it as example

********************************************************
Messing with the VPinball app and push notifications.
So if you haven't downloaded app yet what are you waiting for!?
for IOS and Android

********************************************************

Attachments:

1. cabinet.zip

You need to login in order to like this post: click here

[Josh]

ok so directly placing the cabinet xml did not fix my issues but I think I was able to make headway on my original xml.  The problem with my addressable LED is it actually starts at zero rather than 1 the problem is the xml file wont start at Zero if I lose two columns on each side and set my first led at 8 the pattern looks correct but I obviously lose two columns.  Any idea if  I can fix this or how to fix it?

 

Attachments:

1. cabinet-1.zip

You need to login in order to like this post: click here

[Josh]

Here is a video of the matrix working correctly however the first and last column of my matrix had to be taken out of array to accommodate a the zero start LED

You need to login in order to like this post: click here

[randr]

Interesting. I’m not sure why that would make a difference unless your count is off in xml for leds

********************************************************
Messing with the VPinball app and push notifications.
So if you haven't downloaded app yet what are you waiting for!?
for IOS and Android

********************************************************

You need to login in order to like this post: click here

[Josh]

Has anyone else had this issue I feel like I have tried every combination of start positions to get this to work

You need to login in order to like this post: click here

[Author]

Posts