Forum Replies Created
-
Posts
-
Its not just a setting, as far as I remember you also have to use the 4k pics/videos.
But if you look through the instructions of how to install this theme you will find all the info you need to set it to 4K
https://vpinball.com/VPBdownloads/t-arc-themes-for-pinup-popper/
Okay, I installed a 4K theme and BAM! Everything looks great now! Thanks for the advice!!
Loading vids are still all smushed up at the bottom, but now that I’ve got the new theme I think I’m going to try to apply the transparent loading vids anyway. So we’ll see how that goes. Thanks again @rodclemen!
You need to login in order to like this post: click here
Hi everyone, and thanks to all who contribute to this incredible community, especially Terry! You sir are a godsend!
Now for my issue… I have followed all instructions and interestingly I am getting SSF whenever I start FX3 directly, but when I launch an FX3 table from PUP I don’t get any SSF sounds. Anyone have any suggestions as to what might be happening?
See #7 & #23 – https://www.nailbuster.com/wikipinup/doku.php?id=faq
Wow, that was it!! I had followed a guide to installing DOFLinx that instructed me to set it to run as admin.
Thank you so much for taking the time!
You need to login in order to like this post: click here
So I recently upgraded my playfield tv from a 1080p to a 4k TV. I had used the baller installer to configure my system, and I remember there was an option in the wizard for 1080p or 4k, which I had obviously chosen 1080p. Since I switched over I’ve had two issues. First, my wheel images aren’t sized correctly, and second my loading videos are not showing full screen, but instead in a smallish box on the playfield screen, and they are severely distorted.
Is there any way to re-run the wizard from the installer without doing a full reinstall? If not, does anyone know what settings are configured by that selection in the wizard so I can go in and change it?
You need to login in order to like this post: click here
Hi everyone, and thanks to all who contribute to this incredible community, especially Terry! You sir are a godsend!
Now for my issue… I have followed all instructions and interestingly I am getting SSF whenever I start FX3 directly, but when I launch an FX3 table from PUP I don’t get any SSF sounds. Anyone have any suggestions as to what might be happening?
You need to login in order to like this post: click here
